The DSP Audio Filter is a tool that enables you to filter frequencies from an audio spectrum by using your cell phone’s microphone.
This app was originally programmed for Ham Radio (Amateur Radio)
operators to remove unwanted background noise and improve SSB and CW
signals (Morse Code) but it can be used in different other ways.
-Bird watchers can use it to filter out higher frequencies and eliminate street noise or other disturbing low frequencies.
-Musicians can filter out a spectrum of specific instruments.
Ham Radio Operator’s: Just place your phone’s microphone close to your
radio’s speaker and listen to clear audio in your headphone.
How to use:
DSP Audio Filter uses a waterfall to display the incoming frequency
spectrum. With 2 sliders the cut-off frequencies can be adjust. The
areas which are covered by a grey blurry layer are cut out and they will
not be passed through to the headphone. All other areas will pass the
The DSP Audio Filter can be used with 4 different sampling rates
(22050Hz, 16000Hz, 11025Hz and 8000Hz) which can be set in the settings
menu. Unfortunately not all devices support those sampling rates. The
DSP Audio Filter will check for the supported sampling rates and only
allows the selection of the supported sampling rates.
The Slim Jim is a vertically polarized omnidirectional end-fed antenna having considerable "gain" and this is concentrated almost ...
Arduino is a physical computing platform based on a simple I/O board and a development environment that implements the Processing/Wiring l...
1. Standard Modi - CDI - Non Cut Off - Exhaust Performace - Standard Exhaust - Modi / Performance Same Type - Sprocket Ratio - Top Speed Rat...